P a g e
| 22
Steel Body, Automatic Wood Pellet Feed Hot Water Boiler Operation and Maintenance
Manual
START UP
Operate the boiler by pressing 5 seconds to
ENTER button.
Press the
ENTER button again to set the desired boiler water temperature using the
ARROW buttons then press the
ENTER button to save the value.
The boiler will start working and pre-purge for the set time. Then it will enter Starting, Ignition 1,
Ignition2 modes respectively.
On the first burn, ignition may not occur after these modes are over. Since the fuel supply pipe is
empty, there may not be an ignition at first. After the error message appears on the screen, reset it
by pressing the
ESC button for 5 seconds.
After the firing phases have passed, the boiler goes to power3 and power goes to 4, 5 and 6,
respectively. It works until it reaches the set temperature. It decreases and increases the power
phases when it approaches the set temperature. When it reaches the set temperature, it goes to
sleep (power 0).
After pressing the
mode button, manual or automatic mode can be selected with the help of
arrows. When manual mode is selected, desired power level can also be selected with
the help of
arrows. The levels according to powers are as follows:
Power 6
Power 5
Power 4
Power 3
Power 2
Power 1
100%
80%
60%
50%
40%
30%
