P a g e
| 9
Steel Body, Automatic Wood Pellet Feed Hot Water Boiler Operation and Maintenance
Manual
Burning and flying fuel particles in the boiler, fuel ash from the open door to the outside environment
will easily open the boiler door while operating the fan should never be opened. While the boiler is
burning, the doors should not be opened and hand loading should not be done on the hob or inside
the boiler.
ATTENTION
Never disconnect the power supply while the boiler is operating.
For any reason, no direct cold water should be added to the overheated boiler for cooling. In this
installation, it can cause noise, excessive high thermal stresses in the boiler and therefore permanent
damage. Water should not be drained in the installation unless it is for maintenance or risk of freezing.
The system design should ensure that the ratio between the installation water flow rate and the boiler
capacity and that the 20ºC difference between the boiler inlet and outlet water temperatures is not
exceeded. To minimize the loss of water in the installation, the water level should be checked regularly
and leaks from the system must be removed. Because over water additions to the system will cause
lime to accumulate on the water side of the boiler, which will cause regional overheating and this will
damage the boiler.
ATTENTION
The fuel tank must be added before the fuel runs out.
ATTENTION
The fuel tank cap must be kept closed.
WARNING
For any reason, no direct cold water should be added to the overheated boiler for cooling.
