15
PASO A PASO MODELO UVT1316-21
Nota:
Las imágenes son orientativas y sólo deben ser utilizadas como apoyo
a la instalación.
1.
Instale las aspas en la cabeza del ventilador utilizando los tornillos
suministrados (fig. 1).
2.
Ensamble el alojamiento de la placa LED en el cabezal del ventilador
(fig. 2)
3.
Una los componentes de la varilla de soporte en el orden que indica la
imagen. (fig. 3).
4.
Pase el cable el cable de electricidad por el interior de la varilla y
sáquelo por el otro lado.(fig. 4)
5.
Asemble la varilla de soporte con la cabeza del ventilador (fig. 5)
6.
Ajuste el tornillo de sujección de forma que pase entre la varilla de
soporte y la parte superior de la cabeza del ventilador.(fig. 6)
7.
Bloquee la posición del tornillo con la horquilla. (fig. 7)
8.
A continuación coloque el palo de sujección en el extremo superior de
la varilla (fig. 8)
9.
Fije la posición de la varilla atornillándola (fig. 9)
10.
Deslice la varilla hacia abajo como indica la imagen (fig. 10)
11.
Desafloje el tornillo del cableado (fig. 11) y atorníllelo de nuevo una vez
sacados los cables (fig. 12)