1
STEP 3 & 3b.
DISCONNECT POWER SUPPLY WIRES (BLACK &
WHITE or RED AND WHITE) ON DRIVER SIDE OF FAN BY UNPLUG-
GING OR CUTTING 2”-3” FROM STRAIN RELIEF KNOTS.
Cut Dome Switch Wire
Remove the Fuse
Remove 5 Screws
1b
2
Strip the End
STEP 5c & 5d.
STRIP OFF INSULATION ON THE FAN MOTOR
LEAD WIRE APPROX. 3/8” FROM THE END AND PUT THE BLUE
FEMALE CLIP (provided) ON THE BARE END AND CRIMP IT
SECURELY. CONNECT THE FAN MOTOR LEAD (RED or BLUE)
WIRE TO THE RED AND BLUE STRIPED WIRE ON YOUR NEW
UPGRADED SCREEN ASSEMBLY.
Crimp Blue Female Clip
Open Dome 2/3rds
Unhook Lift-Arm and Remove
Unscrew the Lift-Arm ASM
Feed the Lead Back Up Thru Base
5d
Drop Control Panel
2b
STEP 4 & 4b.
(
If you have a Manual Fan),
REMOVE 2 SCREWS FROM
THE LIFT ARM ASM BASE, UNHOOK THE LIFT-ARM FROM THE DOME SLIDE
AND PULL THROUGH THE SLOT IN THE BASE. PUT NEW LIFT-ARM
THROUGH SLOT IN BASE AND
HOOK TO SLIDE
ON DOME. SECURE LIFT-
ARM ASM TO THE BASE WITH TWO #10 SCREWS.
Cut the Clip Off (only)
5
5b
1
INSTALLATION INSTRUCTIONS
.
Read Instructions Entirely Before Beginning
*
NOTE: ALL ASSEMBLY SCREWS ARE STANDARD #2 PHILLIPS
STEP 5 & 5b.
(IF NOT ORIGINALLY EQUIPPED WITH A REVERSE SWITCH),
UNPLUG THE RED or BLUE WIRE FAN MOTOR LEAD FROM THE 3-
SPEED SWITCH. CUT THE CLIP OFF OF THE FAN MOTOR LEAD.
PULL THE WIRE OUT OF THE BASE FROM THE TOP SIDE.
LOCATE THE HOLE NEXT TO THE DOME SWITCH AND FEED THE
FAN MOTOR LEAD THROUGH TO THE INSIDE (5b).
4b
STEP 2 & 2b.
REMOVE THE LIFT KNOB (MANUAL) OR LIFT
MOTOR (AUTO). NOW REMOVE 3 TO 5 SCREWS FROM THE FACE
OF THE SCREEN ASSEMBLY (ASM)
(removal of the screen is not
necessary)
.
.
5c
Unplug Dome Switch
4
STEP 1 & 1b.
OPEN THE DOME 2/3rds.
REMOVE THE FUSE
FROM BOTH CURRENT AND NEW SCREEN ASSEMBLY BY
PUSHING UP THE BLACK FUSE CAP 1/4 TURN LEFT AND PULL!
(SINCE ‘97 SOME CAPS REQUIRE A SLOTTED SCREWDRIVER)
3
3b
