Universal Remote Control URC-SR3, Owner'S Manual

Page: 34 / 52

Page | 33
Finding a Component’s
Set-up Code Number
If you used the Auto-Search or Learning Methods
to set up a component, you may not know the
code number you programmed. Here is a way
for you to identify what that code number is, so
you can make a note in the back of this Manual
for future reference.
STEP 1: Press the component button you
would like to verify and the SELECT [SEL]
button at the same time for two seconds
until the selected Component light turns on.
STEP 2: Press the [INFO] button and count the
number of times the Component LED light blinks.
This number in dicates the first digit of the code.
Next, it will pause for about one second and
begin blinking again to indicate the number of
the second digit. Then onceagain it will pause,
then blink, to indicate the number of the third digit.
Note:
If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step one.
Example: One blink, pause, eight blinks,
pause, three blinks indicates code num-
ber183. Note that ten (10) blinks represent
thenumber 0.
COMPONENT
BUTTONS
SELECT
INFO