Universal Remote Control URC-SR3, Owner'S Manual

Page: 11 / 52

2. Three-Digit Set-up
STEP 1: Find the 3-digit code numbers for
your component type and brand from the
lists in the back of this manual. The codes
are listed by component type (TV, DVD, etc.),
then by brand name.
Be sure to identify the
list of codes for the correct component and
brand.
For instance, if you would have a
Sony television, first locate the TV category,
and then look for the Sony brand. Be careful.
Codes for Sony DVDs may be different than
from Sony TVs.
You may want to write the numbers down on
a piece of paper before moving to step two.
STEP 2: Turn on the component you want to
activate. (Other components can be on or
off, it doesn’t matter.)
STEP 3: On your URC-SR3 remote, press the
Component button that you want to set up
and the SELECT [SEL] button at the same
time. Hold down both buttons for two seconds
until the Component light turns on.
This signals that you are in set-up mode, and
you can then release the buttons.
STEP 4: Point the URC-SR3 toward the
component and use the number buttons 0-9
to punch in the first 3-digit code for that
specific component.
If the 3-digit code number you just punched
in is the correct number, the component you
are activating will turn off. If it did not turn
off, enter the next code number from your list
until it does turn off.
Note:
If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set-up mode, and
you will have to start over with step three.
COMPONENT
BUTTONS
SELECT
BUTTON
Page | 10