Universal Remote Control URC-SR3, Owner'S Manual

Page: 21 / 52

MacroPower
for Total System On or Off
MacroPower makes several devices work
together while pressing just one button. If
you want to turn on your TV, DVD player
and Cable/Sat receiver by pressing a single
button, you can. Both the Power On and the
All Off buttons can be programmed for
MacroPower control.
Note:
Most components use the same signal
to turn the power on and off. You may want
to set-up MacroPower only in the POWER
[ON] button and save the [ALL OFF] button
to turn components on or off individually.
STEP 1: To set-up MacroPower for the POWER
[ON] button, press the POWER [ON] button
and the Select button at the same time for two
seconds until any one of the Component lights
turns on. Release the buttons before going on to
step 2.
STEP 2: Press the component button you
want to turn on and then press the POWER
[ON] button; repeat for all other components
in the order you want them to turn on. The
Component light will blink once each time
you press the POWER [ON] button.
Note:
If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the set-up mode, and you will
have to start over with step one.
STEP 3: Once you’ve entered all the Power
On commands, press the CHANNEL Up
[CH
5
] button to save your MacroPower
commands. The Component light will blink
two times to confirm that the activation has
been successfully saved. Repeat for All Off
button if desired.
Page | 20
POWER
SELECT
BUTTON