Universal Remote Control URC-SR3, Owner'S Manual

Page: 10 / 52

Page | 9
1. Quick Set-up
Set-up one component at a time, and you’ll
move quickly through your system.
Step 1: Turn on the component you want to
activate. (Other components can be on or
off, it doesn’t matter.)
Step 2: Point your new URC-SR3 Remote
Control toward the component and press the
appropriately labeled Component button (TV
for TV, DVD for DVD, etc.)
While holding this
button down,
press the numeric assigned to
your brand in the Quick Set-up Code Table
(See Page 2) and release both Component
button and the number key to save the code.
The component light will blink two times to
confirm that the code has been stored.
Step 3: Point the remote control at the
component.
Step 4: Press the power button. If it turns
off, it is programmed for your component. If
it does not turn off, use the Pre-Programmed
3-Digit code Method or Scanning Method.
Check your work.
Press the POWER [ON]
button to turn the component back on.
Next, test the VOLUME and CHANNEL buttons
(or PLAY and STOP buttons for DVD) to make
sure they all work. Repeat steps one through
three until all your components are set up prop-
erly.
COMPONENT
BUTTONS
NUMBER
PAD