![background image](http://html1.mh-extra.com/html/unitrol/troll-3100/troll-3100_manual_845416007.webp)
7
7. CONNECTING - UP THE MACHINE TO POWER SUPPLY
7.1 Installation power supply balancing machine
The balancing machine is provided with a three - condictor power cable.
The conductor with YELLOW - GREEN insulation, connected to the balancing machine housing is
a PROTECTIVE conductor.
7.1.1 Connecting of iar supply
The air pipe ended of slide valve connect to pneumatic adaptor (no 8 pic 3) on the back wall of
balancer
7.2. Installation and connection of monitor
Particular description in monitor instruction.
7.3. Test start of balancing machine
In order to check for correct electrical connection of the balancing machine, perform steps described
in item 7.1. and then depress „START” key.
A CHILED BALANCING MACHINE MAST NOT BE CONNECTED TO THE MAINS BEFORE TWO
OR THREE HOURS, NECESSARY FOR DRYING ELECTRONIC COMPONENTS AND TO REACH
ROOM TEMPERATURE. FAILURE TO DO DO MAY CAUSE SERIOUS DAMAGE TO THE
BALANCING MACHINE.
8. OPERATING BALANCING MACHINE COMPUTER
8.1. Switch balancing machine computer
Switch machine master switch on, as well as monitor power supply switch. Balancing machine
will emit announcement [SYSTEM TEST] and them [ SYSTEM OPERATIVE]. Atest pattern shall
appear on monitor screen and then an advertisingimage. After depressing any key of the
keyboard (fig 1) the computer will be set in [UNBALANCE MEASUREMENT] subroutine and the
image shown in (fig 6) will appear on the monitor screen.
NOTE:
If during the inspection test, key
(item.14 fig.1),is depressed,system test will be interrupted
and advertising image display procedure will be interrupted. The computrer will be immediately
set in [UNBALANCE MEASUREMENT] subroutine.
8.2. Select measurement procedure
After depressing the key
computer is set in SELECT PROCEDURE programme and image,
Summary of Contents for TROLL 3100
Page 11: ...11 Fig7b L DISTANCE Fig 7 a ...