Unitrol TROLL 3100, Manual

Page: 10 / 43

10
8.3.1. Entering DISTANCE parameter manualy.
Guide cursor to position.1 (fig.6) over depressing key or keys 17, 18, 19, 20 (fig.1). The
machine will emit [DISTANCE] announcement.
Wheel distance setting should be dtermined as follows:
a) after the positioner has been moved to the rim edge and than back to the start position a
number will be shown which is in a proportion to the positioner move (see fig. 7a)
NOTE:
The positioner must not be in the protruded position during the balancing machine switch - on
and the computer reset. Otherwise the distance measurements will be false as the computer
reads the positioner is position during switch - on as the zero position.
b) in case the distance should be entered without using the positioner the following should be
done:
(look fig.7 b)
- measure with a rule distance L between balancing machine wall and the rim of the wheel
mounted in wheel chuck (measurement in centimetre)s
- multiply the measured value by four and subtract three, according to formula:
DISTANCE = (4 x L) - 3
8.3.2. Entering „DIAMETER” parameter manually.
Guide cursor to position 2 (fig..6)over depressing key or by means of arrow 17 - 20. The
machine will emit [DIAMETER] announcement.
Depressing keys or the value of this parameter is from 10 to 24 inches.
8.3.3. Entering „WIDTH” parameter manually.
Guide cursor to position „3” (fig 6) or by means of arrow 17 - 20. The machine will emit
[WIDTH] announcement. Depressing keys or the value of this parameter is from 2
to 10 inches
8.3.4. Balancing Programm Selection (irrespective of start) Guide cursor to position 4
(fig.6) over depressing key or by means arrow 17 - 20. The balancing machine will emit
[ WHEEL TYPE CHANGE]
By depressing key or it choice of the variant of balancing slug accordingly to the
wheel rim type.