![background image](http://html1.mh-extra.com/html/unitrol/troll-3100/troll-3100_manual_845416041.webp)
41
MEASUREMENT and push - button
. switch on the balancing machine drive in
order to check the extent of unbalance of the tested wheel.
Appearance of zero and outside balancing planes means that the wheel used for calibration
was balanced and the entire calibration process should be considered completed.
5. If reaching according to item 4 proves an unbalanced condition balance the wheel so that
0g is displayed for both balancing planes and then repeat the balancing process according
to items 2 and 3 and check wheel balance according to item 4.
- 0 and 79 or 0 and 80 after test according to items 2 and 3
- 0 and 0 after checking test wheel balance according to item 4 .
NOTE :
A precondition for correct - calibration and correct indications of the balancing machine is its
installation in a dry and dust - free room. Like any measuring wquipment built with the use of
processor systems it has poor moisture resistance. Moisture in the equipment will not result in
lasting damage, but will cause merely indication errors. Therefore in the case of abnormal
measurement results such as high three - figure unbalance values of a car wheel or substantial
indication differences in susequent measurements of the same wheel it is absolutely necessary
to dry the main electronic board of the balancing machine. Removal of the cover and drying
the main board with e.g. a hair dryer does not make the warranty invalid. Moisture most frequently
appears during changing weather conditions ( auttum / winter and winter / spring seasons)
therefore special care should be taken to ensureproper operating conditions for the balancing
machine.
14. PRINTER
Before starting the balancing machine place printer in the socket located in the socket placed
in the top above the keyboard (see Fig 1 item 22) and connect the two printer power supply
cables. After switching printer power switch on ( located on the rearside of the printer, on the
right) LED at the bottom of the printer will light up.
The printer thus started, will automatically print the following data ( after the wheel has been
balanced and noughts displayed on display „1” and „2”
- worshop data, received in HEADING EDIT programme (item. 8.5)
- real time
- date
- wheel data
- measured original unbalance value, for each correction plane
- corrected unbalance (0g) for each correction plane
A key
is used for manual printer control. After each depression of this key, the printer will
Summary of Contents for TROLL 3100
Page 11: ...11 Fig7b L DISTANCE Fig 7 a ...