Mechanical installation
BAMOCAR-D3-700-100/160
Version: 2019 / V05
18
Im
po
rt
an
t n
ot
es
3
Mechanical installation
3.1
Important notes
Check the device for mechanical damage.
Only devices in perfect working order can be mounted.
Disconnect the power supply prior to any assembly.
Disconnect the positive and the negative battery pole and the dc
mains.
The device must only be mounted by suitably trained personnel.
The mounting position of the devices with a liquid cooling unit is
arbitrary.
If the heat is not dissipated sufficiently the device switches off
via its temperature watchdog.
Any bore hole dimensions for the fixation of the device must be taken from the dimension
diagrams or from the drilling plan, not from the device.
The line shields and the mounting plate must have surface-to-surface contact.
The power supply lines (battery line and motor line) must be routed separately from each other.
Observe the min. line cross-section.
A safe earth connection must be provided between the housing and the mass
level (vehicle chassis earth, earth of the switch cabinet)
Unshielded cable heads must be kept short.
Only use specified connectors.
Use vibration-proof screw connections.
Note:
Power supply cables between the BAMOCAR and the battery must be as short
as possible.
Long cables cause dynamic voltage drops due to the line impedance and as a
consequence the service life of the installed capacitors would be reduced.
