Unitek 9100 Series, User Manual

Page: 13 / 34

9100 SERIES REFLOW SOLDERING SYSTEM
990-606 2-1
CHAPTER 2
GETTING STARTED
Section I: Planning for Installation
NOTE: Installation will be done by a Unitek Precision Systems representatives, but you must have the
following accommodations in place to permit installation.
Space Requirements
We recommend that the workstation be installed in a well ventilated area that is free from excessive dust,
acids, corrosive gasses, salt and moisture. Allow adequate space around the workstation for power cabling
runs, and additional space in front for the operator.
Outline drawings of the workstation are included in Appendix A. The approximate dimensions of the
workstation are:
Width: 49 in. (1245 mm) + 17 in. (432 mm)*
Depth 43 in. (1092 mm) + 17 in. (432 mm)*
Height 60 in. (1524 mm) + 28 in. (702 mm )*
* Additional space required to open access doors.
The floor surface must be able to support the weight of the workstation and the operator. The workstation,
with all options, weighs 483 lbs (1064kg).
Power Requirements
Power requirements will vary depending on your configuration. The minimum voltage requirements are:
120 VAC (
±
5%), 16A, single phase, 50/60Hz (for 120V Uniflows)
240 VAC (
±
5%), 16A, single phase, 50/60Hz (for 240V Uniflows; 120V ac power is also required)
Compressed Air Requirements
The workstation requires a source of 80-100 p.s.i. (5.6-7.0kg/cm
2
) compressed air. The workstation is
equipped with a
c
” NPT –
3
inch tube push-in fitting
User Manufactured Jigs, Mounting Hole Requirements
To assist the user in making specific jigs, a hole pattern of the rotary table is provided in Appendix A.