Unitek 6-099-04, Operation And Maintenance Manual

Page: 39 / 88

CHAPTER 3: OPERATING INSTRUCTIONS
MICROPULL
®
IV WIRE BOND PULL TESTER
990-180 3-11
entry. For example, on a 100 gf beam, the ninth entry would contain all of the bonds that broke between
4.5 (9 x 0.005 x 100gf) and 4.9 gf.
CHANGE HEADER INFORMATION
FIELD CONTENTS
Operator's
Name
Part Number
Lot Number
Serial Number 1
Increment Serial No. (Y/N) Y
No. Pulls per Assembly 16
Echo Data to Disk File (Y/N) N
Disk Drive (A, B, C, or D) C
Path Name \MP4\
File Name DATA
Use cursor keys to move, <F9> to change, and <F10> to exit
11 Press <Fl0> to proceed to the Change Header Information Screen. Enter up to 15 characters in the
Operator's Name and Assembly Number Fields. The Serial Number can be numeric or alphanumeric. If
numeric, the Serial Number will be automatically incremented at the completion of each assembly
provided the "Increment Serial No." field contains a "Y". If this field contains an "N", the program will
stop at the end of each test series and wait for the operator to enter a new Serial Number. The maximum
number which can be entered in the "No. Pulls per Assembly" field is 9999.
12 A "Y" in the "Echo Data to Disk File" field will cause all of the data received from the MP4, in either
mode, to be reformatted into a Lotus ".PRN" format and saved to the disk file specified by the contents
of the "Disk Drive," "Path," and "File Name" fields. As shown above, the Path Name must start and end
with a "\". The File Name will always be given the extension ".PRN" and be written in a format that
allows the data to be imported into Lotus 1-2-3. The specified file, C:\MP4\DATA.PRN in this
example, will be over-written whenever the ECHO Feature is selected.
13 Press <Fl0> to exit.
Non-Destruct Testing Program
NOTE: If the printer is not on line, the program will not proceed beyond this point and a "Device
timeout…" error will result.
1 Assuming the appropriate Operator, Part and Lot No. information was entered in the Change Header
Information Screen, the following will be printed at the top of the first page of the report: