![background image](http://html1.mh-extra.com/html/united-states-stove/3000-l/3000-l_operation-and-instruction-manual_4020570006.webp)
6
Ussc
ASSEMBLY INSTRUCTIONS
Blower Assembly
THE BLOWER ASSEMBLY MUST BE DISCONNECTED
FROM THE SOURCE OF ELECTRICAL SUPPLY BE-
FORE ATTEMPTING THE INSTALLATION.
THE BLOWER ASSEMBLY IS INTENDED FOR USE
ONLY WITH A STOVE THAT IS MARKED TO INDICATE
SUCH USE.
DO NOT ROUTE THE SUPPLY CORD NEAR OR
ACROSS HOT SURFACES!
Fix the assembly to the back of the stove with
the four screws provided.
Pedestal Trim Assembly
Assemble trim pieces as shown with the screws provided
in the parts bag. Washers may not be necessary. This may
not be necessary depending on the trim kit you have.
After trim assembly, attach to the pedestal base at
the location shown using the screws provided.
Ash Pan Assembly
If not already installed, slide the ash pan inside the ash
pan housing.
2 BOLTS PER LEG
Leg Assembly
If not already installed or for purpose of repair, follow these
directions. Because of this heaters weight, we suggest
getting assistance maneuvering it into position.
Begin by removing all the firebrick. Carefully roll the heater
onto it’s side, placing a couple wooden blocks to hold
the heater off the legs. A piece of carpet would also help
reduce the chances of scratching the unit. Once you’ve
attached the legs with the supplied hardware, stand the
heater back on it’s legs.
Summary of Contents for 3000 (L)
Page 23: ...23 Ussc NOTES...
Page 24: ...Ussc 24 NOTES...