Enter Setup
15
**
Exit Setup
Access the engine with your program:
1.
Use CreateFile to access the engine as a HID device.
2.
Use ReadFile to deliver the scanned data to the application program.
3.
Use WriteFile to send data to the engine.
For detailed information about USB and HID interfaces, go to
www.USB.org
.
Acquire Scanned Data
After a barcode is decoded, the engine sends an input report as below:
Bit
Byte
7
6
5
4
3
2
1
0
0
Report ID = 0x02
1
Barcode Length
2-57
Decoded Data (1-56)
58-61
Reserved (1-4)
62
Symbology ID Number (Appendix 7) or N/C: 0x00
63
-
-
-
-
-
-
-
Decode Data
Continued
VID/PID
USB uses VID (Vendor ID) and PID (Product ID) to identify and locate a device. The VID is assigned by USB
Implementers Forum. Every PID contains a base number and interface type (keyboard, COM port, etc.).
Product
Interface
PID (Hex)
PID (Dec)
Base 0000
0
MS842N
HID-POS 0010 16
Summary of Contents for MS842N
