P O R T A L
Document Number:
PTL1028
Document Title:
Portal 3 Owners Manual
If more tokens are required, refer to Programming the IDX Acceptor to get the switch locations for that
particular token, and then press the push-button the number of times that is equal to the number of
pulses to be sent for that token.
10.7.6
Erasing IDX Programming
If you need to erase programming or start over, use the following procedure:
1.
Remove the front cover from the IDX acceptor.
2.
Set the rotary switch to the position that corresponds to the coin you wish to re-program or
erase.
3.
Depress the button located immediately to the right of the rotary switch only once.
4.
Return the rotary switch to zero without passing any coins through the acceptor. This will
erase the program that has been stored for that number.
5.
Return the front cover to the IDX.
10.8
Coin Hopper
The Portal TI is engineered with multiple self-aligning connector ports located in the rear of the hopper
cage. This allows up to three units to be installed simultaneously. The figure below shows a block diagram
of a hopper cage designed to hold the Multiple Coin Dispenser option.
In order to remove the coin/bill dispensers, you must first open the cash vault door.
