UniPOS Fire Control Panel FS4000
Instruction manual
Page 26
Revision 11/01.17
of 34
14.1.6. The signal lines cable connection to main interface board.
- For easy wires installation in the PCB connectors, the interface board is mounted to the bottom
holders, as illustrated on fig.11, pos.1.
- The signal cable lines, dedicated for the conventional zones and fire protection and fire alarm
equipment, are fit to the PCB connectors in the main interface board (fig.11, pos. 2), without being
fully tighten. The mains cable is not connected in the PCB connector on this stage, but later on
when the interface board is in its initial position (refer p.4.1.8).
Fig.11