UniPOS Fire Control Panel FS4000
Instruction manual
Page 21
Revision 11/01.17
of 34
- Cut the access level key out from the bottom side of the cabinet (fig.5, pos.3);
- Cut the plastic plugs out from the bottom side of the cabinet (fig.5, pos.2);
Fig.5
Fig.6
14.1.2. Prepare the cable openings
- Take care to fully clean the opening on fig.5, pos.5;
- Do not remove the plastic component (fig.5, pos.1);
- The openings (fig.5, pos.6) and (fig.5, pos.5) are dedicated to the signal lines (conventional
zones and alarm and protection equipment);
- The opening in the top left corner is only dedicated to the 220Vac mains power line (fig.5,
pos.4), applicable for the FS4000 mains power supply;
- The external opening, located on the topside of the cabinet are dedicated for surface mounting
of the signal line (fig.6, pos.2) and mains power line (fig.6, pos.3);