APPENDIX B
-
SP2100 2D Imager Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
2D
Im
ag
er
O
nly
Programming “ON”
Programming “OFF”
Figure B.0
Instructions:
To change the option, first scan the
Programming “ON”
barcode.
Then scan the Option Code. Finally scan the
Programming “OFF”
barcode.
32
B.11 - Code 39, con’t
Code 39 - Check Digit
Don’t Transmit
Code 39 - Transmit
Check Digit
Code 39
No Check Digit
5.
Scan the
Save Programming
barcode, then scan the
Programming “OFF”
barcode.
Code 39
Full ASCII OFF
Code 39
Full ASCII ON
B.12 - Codabar
Enable
Codabar
Disable
Codabar
Set Codabar
Factory Defaults
Code 39 MAY be encoded with a check digit. The check digit is optional.
Min and Max String Lengths
- To limit the length of the barcode string as a form of validation, you can set a minimum and
maximum string length. These lengths include check and stop/start digits if applicabl to the symbology. To set the string length:
1.
Scan the
Programming “ON”
barcode.
2.
Scan the
Set Min Length
barcode, then scan the digit code(s) from
Section B.29
of this Appendix (B) for the number
representing the minimum length.
3.
Scan the
Save Programming
barcode.
4.
Scan the
Set Max Length
barcode, then scan the digit code(s) from
Section B.29
of this Appendix (B) for the number
representing the minimum length.
Set Codabar
Min Code Length
(Default = 2)
Set Codabar
Max Code Length
(Default = 60)
NOTES:
* String length must be less than 127 bytes.
* MAX LENGTH must be less than or equal to MIN LENGTH.
* If MIN LENGTH = MAXLENGTH, only that single length barcode
string will be allowed.
Codabar - Check Digit
Don’t Transmit
Codabar - Transmit
Check Digit
Codabar
No Check Digit
5.
Scan the
Save Programming
barcode, then scan the
Programming “OFF”
barcode.
