Unimac AIRSAWUMCAH16 User Manual Download Page 8

Page: 8 / 12

AIR METAL SAW

Operation

Work Piece and Work Area Set Up

1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to

prevent distraction and injury.

2. Route the air hose along a safe route to reach the work area without creating a tripping hazard or exposing the air

hose to possible damage. The air hose must be long enough to reach the work area with enough extra length to
allow free movement while working.

3. Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.

4. There must not be hazardous objects (such as utility lines or foreign objects) nearby that will present a hazard

while working.

General Operating Instructions

This Saw may be used for cutting through copper, sheet metal, aluminum, and plastic.

When cutting sheet metal, the angled face of the Blade Guard should rest on the plate to minimize its chatter,
allowing for smoother cutting action.

WARNING:

Do not exceed the maximum 16 gauge thickness when cutting sheet metal with this Saw.

Doing so

can cause serious injury and damage to the tool.

WARNING:

Do not use a dull or cracked blade. Check that the blade and Blade Guard are secured tightly before

every use. Operate the Saw with two hands. Hold the Housing and throttle with one hand, keeping your forefinger
behind the Safety Catch. Hold the front end of the tool with your other hand. Keep all fingers behind the handle recess
but do not cover the Chuck vent holes.

WARNING:

Failure to use two hands may cause the Saw to vibrate out of your control causing serious injury.

1. Once the blade is securely installed, push the Safety Catch forward to release the Throttle. Then press down

on the Throttle to activate the Saw.

2. Contact the workpiece allowing the Saw to do the cutting for you. Do not exert excessive pressure on the

workpiece.

NOTE:

If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed

airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this
tool. If the tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be
required.

3. To prevent accidents, turn off the tool, detach the air supply, safely discharge any residual air pressure in the

tool, and release the throttle and/or turn the switch to its off position after use. Clean external surfaces of the
tool with a clean, dry cloth. Then store the tool indoors out of children’s reach.

WARNING: To prevent tool and accessory failure, resulting in injury, do not exceed the tool’s maximum
air pressure rating.

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC `

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC