Unigas PBY1025, Manual Of Installation - Use - Maintenance

Page: 22 / 119

C.I.B. UNIGAS - M039126CE
22
Connecting the pump
According to the pump provided, proceed as follows:
1
emove the closing nuts A and B on the inlet and return connections of the pump;
2 connect the pump
being careful to avoid exchanging the lines
: see the arrows marked on the pump.
For further information, refer to the technical documentation of the pump.
Connecting the oil flexible hoses to the burner
To connect the flexible oil hoses to the pump, proceed as follows, according to the pump provided:
1
remove the closing nuts
H
(on the heater) and
R
(on the oil pressure governor) of the inlet and return connections;
2 screw the rotating nut of the two flexible hoses on the burner
being careful to avoid exchanging the inlet and return lines
: see
the arrows marked that show the inlet and the return.
Connecting the compressed air hoses
To connect the compressed air supply, refer to the following pictures
Legend
A - Inlet
B - Outlet
C - Overflow pressure adjusting
screw
Fig. 19 - Kral Fig. 20 - Cucchi
A
B
C
A
B
C
H (1”)
R (1”)
Compressed air pressure governor
Compressor