PART IV: MAINTENANCE
42
MultiBloc MBE
MultiBloc VD Mounting
Removing the combustion head
position
to push
1. Position VD on VB, fig. 2+3.
2. Slide VD forward up to the stop, fig. 4.
3. Screw VD on with 2 M5 screws for each, max. 5 Nm/44 in.-lb., fig. 5/6.
4. VD can be mounted rotated by 180°, fig. 7.
1
2
3
4
5
6
7
Remove the lid C.
Unscrew the screws V holding in position the manifold G and pull out
the complete group as shown in figure.
Note: for the subsequent assembly carry out the above described
operations in the reverse order, checking the correct position of the OR ring.
To remove the combustion head, pull it out. Once removed, check that the air
and gas holes are not obstructed. Clean the combustion head by means of
compressed air or scrape off the scale using a metallic brush
VRT
OR
V
AR
G
C
