19
3. System
Programming
Introduction
All system programming is carried out from the master extension or a PC running the programming
tool, connected via the V24 option card. The master extension is extension 12 on the 206 system,
and 13 on the 208/212 systems. To program the system, a tone telephone must be used. The
Executive Terminal simplifies the operation further by providing full menu driven programming on
its built in display. The factory defaults on power-up before any programming are shown on page 84.
After programming features, the power must not be switched off for six minutes. This is to
ensure the system has written all the programming details to the non-volatile system
memory (EEPROM).
How to Program the System
Step 1:
Lift handset of master extension. This is 12 (206) or 13 (208/212).
Step 2:
Enter the Programming Code shown in this section.
Step 3:
Wait for confirmation tone, three short beeps.
Step 4:
Repeat at step 2 for further codes, or hang up.
Remember to keep the system powered up for a minimum of 6 minutes following the last
programming step.
Repeat this procedure for each programming step.
Throughout the Programming section there are boxes like the one below, which show where codes
may be found in the Executive Terminal programming menu. These menus ensure the correct codes
are always sent and are the preferred method of programming where available. This method of
programming is dealt with on page 20.
SYSTEM SETTINGS
Miscellaneous
Example menu item
During system programming, the installer must listen for -
Confirmation Tone (3 short beeps) after the Programming Command has been entered, or
Error Tone, an interrupted tone like busy tone, indicating that Programming Code has not
been accepted.
A list of the different tones may be found on page 84. For all codes that require an extension number
at the end, it is possible to program multiple extensions by repeating the extension numbers, ending
with a final ‘#’. This is an example of a multiple extension code:
E.g.: allocate call bar class C (0 to 5) to extensions 11,13 & 21
Reset System
There is a master reset code to restore factory defaults and erase all programmed data, except the
system configuration pin code and clock which will remain as per previous settings.
Master Reset Code
Section
3
Important!
PIN
C
PIN
