30
liquid Damage
CaUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe
it off and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and
cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent
faces down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers and reconnecting cords.
resetting handsets
The base can register up to 10 handsets. If you have trouble with a
handset or if you want to replace one, clear the registration information
from the base and the handset:
1. Press and hold
end
and
#
at the same time until you see the
System
Reset
menu.
2. If you still have the base the handset is registered to, select
Deregister
HS
, then select the handset you want to reset. If you don’t have that
base anymore, select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
registering handsets
If you see a “not registered” message on a handset, you must register it
to a base before using it.
1. Place the handset in the base; the display should say
Handset
Registering
.
2. Wait until the display says
Registration Complete
(about 30 seconds),
then pick up the handset; press
Home/FlasH
.
#
If you don’t hear a dial tone or the display says
Registration Failed
,
charge the battery completely, then try again.
XDECT6135BTU.indd 30
21/02/12 1:07 PM
