15
SETTING UP YOUR SCANNER
FIRST STEPS
To get your scanner ready for use, follow these quick steps:
1.
Install the battery pack and plug the included cable into the scanner’s USB mini port and the
other end into a PC.
2.
Turn on the scanner by pressing
for about 2 seconds.
3.
When prompted, select
Mass Storage
mode.
4.
Run Sentinel.
5.
Follow the steps provided on the previous page to update the scanner’s firmware and radio
database to the latest versions.
INITIAL SETTINGS
1.
Turn on the scanner by pressing and holding
for about 2 seconds.
2.
Tap the scroll control to display the volume level. Turn the scroll control (within 3 seconds) to
adjust the volume.
3.
Tap the scroll control again to close the volume level (or let it disappear after 10 seconds).
4.
Press
Func
then tap the scroll control to display the squelch level.
5.
Tap the scroll control again to close the squelch level.
To begin scanning right away, press the
Zip
button to select your country and zip/postal code. The
scanner loads channels for your area from the database and starts scanning.
CONTROLS AND INDICATORS
The following table includes the most common functions for each key. It is not, however, a
comprehensive list for all functions in all modes. See specific functions in this manual to perform a
particular task.
The two LED indicators above the display indicate charge status (right LED; red when charging,
green when charged) and channel alert indication (left LED).
Summary of Contents for SDS100
Page 1: ...2018 Uniden America Corporation Printed in Vietnam UOl UB383ZZZ O SDS100 Owner s Manual...
Page 6: ......
Page 61: ...55...
Page 62: ...56...
