86
Creating a multi-point route I have tapped the ‘Route To’ button once for each
destination but only the last one appears in the list, all previous points have
disappeared.
The ‘Route To’ button is for starting a new route only. For a single route you tap
this when the destination is selected. Multi-point routes can be created after you
have established a single route. Add points to the single route by using the ‘Add
Via’ and ‘Continue’ buttons. Applying ‘Route To’ again will delete the whole route.
In your case only single routes existed before, so they were deleted without a
warning message. If you already have a multi-point route, Uniden Navigation warns you
before deleting the whole route. Sometimes the operating system disables the autorun
feature. The best you can do is to soft reset* your GNS8430/8435 . That should restore
autorun functionality. If you choose not to initiate a reset, please look for the Uniden
Navigation 2006 strip on the Today screen, or the Uniden Navigation icon in the Start/
Programs section of the operating system to run Uniden Navigation manually. You
will still be able to exit Uniden Navigation by removing the card.
The speaker icon shows Uniden Navigation is not muted yet I hear no voice
guidance.
The muting available from both map screens is just a quick silencer that cancels the
sound output. Voice guidance and key sounds need to be enabled and volume must
be set at the Sound Settings screen (Page 59).
I enabled the speed warning as soon as I bought the product but I have just
been fined for speeding because Uniden Navigation failed to warn me.
For an accurate speed warning the actual speed limits of each street and road must
be present correctly on the map. This is a relatively new feature of digital maps, so
it may not be available in some countries, and its accuracy still has much room for
improvement (ask your local dealer for the details in your region). This feature can
help you in several cases but it cannot be considered as serious speed control.
That is why it can be turned on and off separately from the reliable voice guidance
(Page 55). Sometimes the operating system disables the autorun feature. The
best you can do is to soft reset* your GNS8430/8435. That should restore autorun
functionality. If you choose not to initiate a reset, please look for the Uniden
Navigation 2006 strip on the Today screen, or the Uniden Navigation icon in the Start/
Programs section of the operating system to run Uniden Navigation manually. You
will still be able to exit Uniden Navigation by removing the card.
I would like to create a new POI during navigation (Cockpit screen) but there is
no Add POI button in the Cursor menu.
For driving safety reasons the Add POI function is only available on the Map
screen. Mark the point with a Pin, and save it as a POI later, when you reach your
destination. If you are not driving, just press the 4th hardware button to switch to
Map mode, where the Add POI button is available. Sometimes the operating system
disables the autorun feature. The best you can do is to soft reset* your GNS8430/8435 .
That should restore autorun functionality. If you choose not to initiate a reset, please
look for the Uniden Navigation 006 strip on the Today screen, or the Uniden
Navigation icon in the Start/Programs section of the operating system to run Uniden
Navigation manually. You will still be able to exit Uniden Navigation by removing the
card.
