Uniden BCD325P2, Owner'S Manual

Page: 74 / 132

74
To Toggle ‘Hold’ mode on a background Scan/Srch press Hold .
To Return to Scan mode press
Scan/Srch
.
Press GPS again to view GPS Display Mode.
To View ‘Review Location’ Mode press E/yes .
Notes: All sites/groups (with quick keys enabled and gps enabled for the site/
group) not within range of your current location will be temporarily locked out.
If you try to use a quick key to enable a site/group for scan that is out of range
of your current location, you will see ‘Location L/O’ and then site/group name
(only once), and it will temporary lock out the site/group.
If you disconnect/turn off your GPS unit, you will see ‘No GPS Input’ in GPS
display mode and the scanner will return to scanning any sites/groups that
the scanner did not temporary lock out. To restore all sites/groups, cycle the
scanner off then on.
If you lose the satellite signal, you will see ‘Searching for Satellite’ until the
GPS unit reacquires a signal.
If a GPS is detected as soon as the scanner is turned on, the scanner displays
“GPS CONNECTED” instead of displaying individual lock/unlock messages for
groups/sites. It applies the location-based rules to all systems at one time.
GPS REVIEW LOCATION MODE
If you have programmed data for a Point of Interest, Dangerous Crossing, and a
Dangerous Road, you can review the type, range setting, and location information
for each location.
Hold on any channel and press Func then E/yes(gps) to enter GPS display mode
then press E/yes. The most recently stored location is displayed. Use the scroll
control to display the next screen for review.
Note: the scanner will mute in this mode.
Important: while you are in Review Location Mode and press and hold GPS for 2
seconds, the data of the new point will overwrite the currently displayed data.