Uniden BCD325P2, Owner'S Manual

Page: 36 / 132

36
When you select ‘AUTO’ for a channel or mode’s modulation or step, the above
values are used unless you’ve edited the Band Defaults. Although TV bands are
listed, the scanner cannot decode digital TV audio.
SETTINGS MENUS
To Edit Settings press Menu .
Scroll to ‘Settings’ and press E/yes .
Scroll to the settings and options below (in Blue) and press E/yes .
Set Backlight Set GPS Format See Scanner Info
Adjust Key
Beep
Set GPS Baud Rate Locking/Unlocking the
Keypad
Battery Option Band Default Viewing Battery level
Adjust Contrast P25 LP Filter Cloning
Set C-CH
Output
Disp. Unit ID Scanner Reset
Set Backlight
To use the backlight press . There are 5 different ways to use the backlight and
3 light intensities.
1.
Scroll to ‘Set Backlight’ and press E/yes .
2. At ‘Set Mode’ press E/yes .
3. Scroll to 1 of 5 settings and press E/yes to save and exit.
10 sec - The backlight stays on for 10 seconds after you press .
30 sec - The backlight stays on for 30 seconds after you press .
Squelch - The backlight turns on when the squelch opens then stays on
for 5 seconds.
Keypress - The backlight turns on when any key is pressed then stays
on for 10 seconds.
Infinite - The backlight turns on when you press then stays on
until you press again.
4. Scroll to ‘Set Dimmer’ and press E/yes .
Scroll to ‘High’, ‘Middle’, ‘Low’ or ‘Off’ and press E/yes to save and exit.
5. Press
Menu
to return.