Uniden BCD325P2, Owner'S Manual

Page: 63 / 132

63
Set Modulation (conventional only)
This setting selects the modulation used for the channel. The default setting is Auto
(NFM for FM channels).
1.
Scroll to ‘Set Modulation’ and press E/yes .
2. Scroll to Auto, AM, NFM, FM, WFM, or WFM Broadcast and press E/yes to
save and exit.
Note: You can also toggle modulation for a conventional channel in hold mode
by pressing Func then 9(mod).
Set Attenuator (conventional only)
This setting controls whether the scanner attenuates signals on The channel by
about 20 dB. The default setting is off.
1.
Scroll to ‘Set Attenuator’ and press E/yes .
2. Scroll to On or Off and press E/yes to save and exit.
Note: You can also toggle attenuation for a conventional channel in hold mode
by pressing Func then 7(att).
Set Priority
This setting controls whether the scanner treats the channel as a priority channel
while scanning. The default setting is off. See also Priority Scan/Priority ID Scan/
Priority Plus Scan.
1.
Scroll to ‘Set Priority’ and press E/yes .
2. Scroll to On or Off and press E/yes to save and exit.
Note: To use Priority ID Scan you must also enable Priority ID Scan for each
system
.
Set Alert
This setting controls when and how the scanner alerts you if the channel becomes
active.
1.
Scroll to ‘Set Alert’ and press E/yes .
2. Scroll to ‘Set Alert Tone’ and press E/yes .
3. At ‘Set Tone’ scroll to the alert (Alert 1-9 or Off) and press E/yes .
4. At ‘Set Level’ scroll to ‘Level 1-15 or Auto’ (the scanner sets the alert beep to
the master volume level) and press E/yes .
5. Scroll to ‘Set Alert Light’ and press
E/yes
.
6. Scroll to Off, On, Slow Blink, or Fast Blink and press E/yes .