Uniden BCD325P2, Owner'S Manual

Page: 110 / 132

110
Note: You can also turn on weather alert in scan or search modes by pressing
and holding the WX button. Press WX again, then scroll to ‘Alert Only’, ‘SAME
1-5’, or ‘All FIP’ and press
E/yes
.
1. Scroll to ‘Weather Alert’ and press E/yes .
2. Scroll to 1 of 7 options and press E/yes .
Alert Only - the scanner immediately sounds a weather alert siren when
it detects the 1050 Hz weather alert tone, then opens the squelch and
remains on the weather channel.
SAME 1-5 - the scanner sounds a weather alert siren for the
programmed county, then opens the squelch and remains on the weather
channel.
All FIPS - the scanner sounds a weather alert siren for any programmed
county, then opens the squelch and remains on the weather channel.
Using Fire Tone-Out
With the tone out feature, the scanner monitors up to 10 different channels for paging
tones (two-tone sequential, single tone, and group tone). See also Hardware: Tone-
Out at WPA Scanner.
Tone-Out Standby Mode is used if you know and use programmed
tones.
Tone-Out Search Mode is used if you don’t know the tones.
Setting up Tone-Out
1. Press MENU . Scroll to ‘Tone-Out for...’ and press E/yes .
2. Scroll to ‘Tone-Out Setup’ and press E/yes .
3. Scroll to ‘Tone-Out 1’ and press E/yes .
4. At ‘Edit Name’ press E/yes . See Entering Text.
5. Scroll to ‘Set Frequency’ press E/yes .
6. At ‘Edit Frequency’ press
E/yes
. Enter the frequency to monitor for Tone-Out
and press
E/yes to save and exit.
7. Scroll to ‘Set Modulation’ and press E/yes .
8. Scroll to Auto, FM, or NFM and press E/yes to save and exit.
9. Scroll to ‘Set Attenuator’ and press E/yes .
10. Scroll to On or Off and press E/yes to save and exit.
11. Press Menu to return.
12. Scroll to ‘Set Tone’ and press E/yes .