60
61
Troubleshooting
Changing the Line Mode for Multiple Extensions
Line.mode.refers.to.the.method.that.telephones.use.to.signal.each.other.that.an.extension.is.in.use..Customer.
service.may.recommend.changing.the.line.mode.if.you.have.any.of.the.following.problems:
•.Your.phone.keeps.ringing.after.someone.answers.on.an.extension.phone.
•.Your.answering.system.doesn’t.stop.recording.when.you.answer.on.an.extension.phone.
•.Caller.ID.displays.briefly.and.then.clears.
1).If.you.set.from.a.handset.and.you.have.multiple.bases,.select.the.base.that.is.having.problems.(see.page.15).
2).Press.
MENU/SELECT
..
3).Select.the.
Global Setup
.menu,.and.then.the.
Set Line Mode
.submenu..
4).
If Instructed by Customer Service Press [select]
.appears..Press.
MENU/SELECT
.
5).Move.the.cursor.to.select.
Type - A
,.
Type - B
,.or.
Off
.
6).Press.
MENU/SELECT
..You.will.hear.a.confirmation.tone.
Traveling Out of Range
When.the.handset.is.in.standby,.the.handset.will.display.
Out Of Range
.
During.a.call,.if.you.move.your.handset.too.far.from.your.base,.noise.may.increase..If.you.pass.the.range.limit.of.the.
base,.the.handset.will.beep,.display.
Out Of Range
,.and.then.go.to.standby..The.base.will.maintain.the.connection.
for.thirty.seconds.after.the.handset.goes.out.of.range..If.you.move.the.handset.back.within.range.of.the.base.within.
thirty.seconds,.press.
TALK/FLASH
.or.
.to.pick.up.the.call.again.
Note:.. If.it.is.set.to.automatically.select.the.available.base,.the.handset.will.begin.searching.for.another.base.thirty.
seconds.after.going.out.of.range..(see.Selecting.the.base.on.page.15).
