UnicornHygienics Multivend, Technical Reference Manual

Page: 9 / 36

Hang the dispenser back up on the wall with the first screw through the triangular hole
again, insert the four mounting screws through the corner holes in the back of the cabinet,
and tighten them securely.
1.4.5 Establishing accurate mounting
Check the action of the door and lock. It is essential that it closes cleanly without lifting or
twisting. If any misalignment is seen this is probably caused by an uneven wall, and you
may need to take the dispenser down to pack one of the mounting points away from the
wall. Repeat this step until the door closes satisfactorily.
1.4.6 Securing the dispenser (plastic m/c only)
Check that the security screw is
tightly in place, and that the
dispenser cannot be wrenched
upwards off the brackets -
particularly the unsecured lower
one. Replace the money box.
1.4.7 Loading the dispenser
Fill all the shelves with the
appropriate products.
Note that tuck-in cartons
have one good folded edge
and the tucked-
in side “open”
for finger access. Put the
smooth folded edge as the
right rear corner for the cam
to push against.
1.4.8 Installing the Power Pack
Remove the rightmost battery strap screw in the door, put the Power Pack in the cradle
with the label towards you and the lead at the bottom. Do NOT connect the power pack.
Replace the battery strap and re-tighten the screw.
Security
screw