4
SHELF ADJUSTMENT FOR CHANGE OF PACK SIZE
a)
With reference to Figure 3-2, disconnect the motor power lead from the motor loom
(25).
b)
Remove and retain the two screws (29) at the rear of the shelf and remove the shelf
from the cabinet.
CAUTION - Do not pull the shelf pusher bar (Red) beyond the end of the aluminium
slide, as the wheels etc. will fall out.
c)
Pull the pusher bar (23) to the left to enable three or more of the products to be
loaded onto the shelf.
d)
Adjust the front guide (30) by pushing from the right so that the teeth are free of the
rack. Push the front guide towards the product until it just touches, release the front
guide to engage the teeth in the rack. The endways pack freedom should be the
minimum possible.
e)
Set the product width adjuster (27) on the right of the front guide to show
approximately 20% of the second product, by releasing the adjuster from its clip and
sliding along the ratchet.
f)
Remove the product (26) from shelf below.
g)
Measure the product height and add 18 mm, make a note of this measurement. Mark
a line on the case back face this distance below the bottom of the shelf above.
h)
Position the shelf against the cabinet rear securing rack
(24) with it’s lower edge at the
mark made in paragraph (g) to set the shelf height. Fit the shelf into the slot at the
side of the cabinet and ensuring the shelf is straight and level secure the shelf at the
rear using the two screws (29) retained in paragraph (a).
i)
Connect the motor power plug (25) to the motor loom socket.
j)
Load the product (26) onto the shelf and replace the product on the shelf below and
test the shelf operation.
NOTE - According to the height of the product fitted, it may be necessary to adjust the
shelves below the one changed, using the same procedure.
k)
When the shelves are adjusted correctly, carry out the check procedures as per Section
2 to ensure the dispenser is operating correctly.
l)
Carry out customer handover procedures as per Section 2.
Summary of Contents for Multivend
