UnicornHygienics Multivend, Technical Reference Manual

Page: 7 / 36

1.3.3 Locally supplied fittings
➢
For fixing to wood or plasterboard walls - suitable butterfly fasteners
➢
For fixing to stepped walls (half tiled) - scrap hardboard equal to the step difference
1.3.4 Location
Select a suitable prominent site. A conspicuous location discourages misuse. Take care not
to obstruct access to other fittings, door opening arcs etc.
Choose a strong masonry wall if possible. The installation must be strong enough to
prevent the dispenser from being pulled away from the wall in the event of vandalism or
misuse. If the customer’s chosen site is un suitable, explain the problem and suggest a
more appropriate alternative.
1.4 Installation procedure
1.4.1 Unpacking the dispenser
Remove the dispenser and all other parts from the packing case. Lay the unit on its back
on the floor. Use your master key to unlock and open the door. The key turns clockwise
180° to unlock, anti-clockwise to lock.
1.4.2 Locating the lower bracket on the wall (Fig 1-1 for plastic m/c only)
The plastic dispenser is attached to
the wall by two identical metal
brackets, allowing the machine to be
later removed / replaced simply by
removal of a security screw.
Mark the position of the lower bracket
on the wall as shown in Figure (1-1).
Mark the position of the left mounting
hole through the bracket peg, and drill
and plug this hole. Using a No. 12
screw provided loosely attach a
bracket to the wall, level the bracket,
and mark the right screw position.
Drill and plug the right hole and insert
the second screw. Tighten both
screws to secure the lower bracket to
the wall.
1.4.3 Positioning the upper bracket
(plastic m/c only)
Raise the top of the dispenser, put the
upper bracket in from behind and fully
engage the two mushroom-headed