5686G-PRO User Guide
Page
67
of
94
Copyright © 2018 USR, a Division of UNICOM Global
Hardware Flow Control
The table below lists the Hardware flow control template. To load this template send
AT&F1
to your
modem.
NVRAM Options
Setting
Description
Handshake option
B0
ITU-T answer sequence
Command mode echo
E1
Enabled
Online local echo
F1
Disabled
Speaker control
M1
ON during dial through connect
Result codes
Q0
Enabled
Verbal or numeric result codes
V1
Verbal result codes
Result code subset
X7
Extended. Includes all codes
except VOICE
Profile used at reset
Y0
At reset use stored profile 0
Protocol response codes
&A3
Full protocol codes
Serial port rate select
&B1
Serial port rate fixed higher than
connect rate
Guard tone
&G0
U.S./Canada
Transmit data hardware flow
control
&H1
Hardware flow control
Received data software flow
control
&I2
No pass-thru
Analog data compression
&K1
Enabled
Error control/sync
&M4
Normal/error control
Highest Link rate select
&N0
Variable
Pulse dialing type
&P1
U.S., Canada, and other countries
Received data hardware flow
control
&R2
Enabled
Data Set Ready
&S0
Always on
Remote Digital Loopback (RDL)
&T5
Deny RDL
Lowest Link rate select
&U0
Variable
Break handling
&Y1
Clear buffer, send immediately
Caller ID
#CID=0
Caller ID disabled
Set Compression Method
+DCS=1,0
Enable V.42bis, Disable V.44
Set Compression Report Mode
+DR=0
Disable the report
Set V.42 Compression Method
+DS=3,0,2048,32
Accept V.42bis, don’t disconnect
if fail, 2048 dictionary, 32 string
