5686G-PRO User Guide
Page
62
of
94
Copyright © 2018 USR, a Division of UNICOM Global
Command
Function
#CID=
n
Controls the caller ID settings.
#CID=0
Disable caller ID detection and reporting.
#CID=1
Enable caller ID with formatted output.
#CID=2
Enable caller ID with unformatted output.
#CID=3
Enable caller ID with formatted output and name suppressed.
#CID=4
Enable caller ID but do not transmit the information to your computer -
retain it in the modem’s memory.
#CID?
Display the current caller ID settings.
#CID=?
Display the caller ID actions that are available.
V.80/V.250 Command Set
Command
Function
+DCS=n,m
Use this command to configure the available compression algorithms. The n
parameter enables or disables V.42bis, and the m parameter enables or
disables V.44. This command works in conjunction with the &K command,
and the result of either the &K command or the +DCS command replaces the
current data compression configuration.
n=0
Disable V.42bis.
n=1
Enable V.42bis.
m=0
Disable V.44.
m=1
Enable V.44.
m=2
Enable V.44 for V.92 servers only.
+DCS?
Display cDCS setting.
+DCS=?
Display list of valid +DCS settings.
+DR=n
Use this command to enable or disable the compression report. If the
compression report is enabled, the +DR:<type> intermediate result code
reports the current data compression type. It is issued after the error control
report (+ER) and before the final result code (e.g., CONNECT).
n=0
Disable the compression report.
n=1
Enable the compression report.
+DR?
Display cDR setting.
+DR=?
Display list of valid +DR settings.
