Unico MCV85 TOTAL CLEAN & TURBO, Instruction Manual

Page: 41 / 116

ENGLISH
| 41 |
Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com for the up-to-date list) or
Customer Services.
ALARMS CAUSE SOLUTION
Boiler fault. Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
The boiler does
not reach the
desired
temperature. Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
The pump
continues to take
in water. Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 1st steam adjustment LED flashing
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 2nd steam adjustment LED flashing
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 3rd steam adjustment LED flashing
PROBLEM CAUSE SOLUTION
The appliance is pressurised but releases little
steam. The steam is set to the minimum level. Press the steam adjustment button (+) to increase
the steam being dispensed.
There is a bad smell when turning on suction. Dirt collector is dirty or too wet. Clean the dirt collector as described in Chapter 13
or simply dry it out If the smell persists, carry out a
full clean as described in Chapters 13, 14, and 17.
Steam is dispensed mixed with drops of water. The steam hose and/or the telescopic
tube are cold. Direct the steam jet onto a cloth to heat up the
tubes.
The holder with cloth for steam cleaning does
not lock onto the brush. The brush is in position B or C. Set the universal brush to position A.
Accessories are difficult to assemble. The seals produce friction. Lubricate the gasket with silicone grease or
Vaseline, or alternatively with a small amount of
vegetable oil.
Steam or condensation leaks out between the
handle and the telescopic tube. Seals worn, cut or missing. Replace the seals, as indicated in Chapter 24.
The filling pump of the boiler continues to
operate. There is air in the boiler circuit. Turn off the appliance and leave it to cool, then
repeat the operations described in Chapter 1.
After vacuuming, traces of liquid remain on the
flooring. Liquid remains inside the tubes.
Floor not yet dry
Suck in air for a few seconds to allow the transfer of
the liquid to the tank.
Repeat the vacuuming.
UNICO MCV80-MCV85 - M0S11431 - 1Q09:UNICO 30/08/2016 16.17 Pagina 41