Unico MCV85 TOTAL CLEAN & TURBO, Instruction Manual

Page: 39 / 116

ENGLISH
| 39 |
blockages and/or foreign bodies which could block the suction
flow. Perform the operation also on the side of the HEPA filter.
3 - Cleaning the tube between collector and machine body
(HEPA filter side): Perform the cleaning operation by inserting
the brush into the tube making sure that there are no blockages.
It is recommended that the tubes be cleaned every time the
filters are cleaned and after every intensive use of the product.
23. REPLACEMENT MULTIBRUSH RUBBER
INSERTS
(extraordinary maintenance)
The rubber strips of the Multibrush, when worn down, can be
replaced with spare parts.
There are two rubber inserts:
- one marked with the letter (F), to be inserted in the front part
of the brush.
- one marked with the letter (R), to be inserted in the rear part
of the brush.
To replace it, proceed as follows:
23.1 Put the Multibrush in position B and turn it upside down.
23.2 Move the rubber insert to the left, then lift it upwards.
23.3 Insert the new rubber insert performing the procedure in
reverse.
The rubber inserts are sold at Polti Authorised Service Centres.
24. SPARE SEALS
Periodically check the condition of the seal on the handle of
the hose and the telescopic tube. If necessary, replace with the
corresponding spare part, as described below.
25. STORAGE
25.1 Turn off the appliance and disconnect from the mains
electricity.
25.2 Pull the power cable gently towards you to activate the
automatic winder, guiding it gently back into the appliance.
25.3 The hose and flexible hose can be housed on the body of
the appliance, sliding the universal brush into the parking
system on the appliance.
Before storage, we advise quickly drying the filter and the
collector with a cloth to avoid unpleasant odours forming.
26. FRESCOASPIRA
FrescoAspira is an ambient deodorant which contains natural
essences. During use, it releases a fresh perfume in every room.
How to insert / replace FrescoAspira:
26.1 Ensure that the appliance is switched off and disconnected
from the mains.
26.2 Disconnect and pull out the dirt collector.
26.3 Insert the FrescoAspira into the dedicated space in the
HEPA filter (46).
26.4 Reassemble all the parts following the procedure in
reverse order.
We recommend replacing it every 2 months or in any case when
the air freshening essence is depleted.
Aromatic contains:
ETHANONE,1-(HEXAHYDRO-TETRAMETHYL-
METHANONAZULENYL) - ALPHA-METHYL-1,3-
BENZODIOXOLE-5-PROPIONALDEHYDE - MIX GERANIOL
NEROL ACETATE
Clean contains:
2-PENTYL-3-PHENYL-2-PROPEN-1-AL - OTNE (1-(1,2,3,4,5,6,7,8
Octahydro-2,3,8,8-tetramethyl-2-naphthalenyl) ethanone) - 3-
METHYL-4-(2,6,6-TRIMETHYL-2-CYCLOHEXEN-1-YL)-3-BUTEN-
2-ONE (MAIN COMPONENT) - ACETATO P-T-BUT-CICLOEXILE
- 3,4,5,6,6,PENTAMETHYLHEPT-3-EN-2-ONE (AND ISOMERS) -
7-HYDROXY-3,7-DIMETHYLOCTAN-1-AL
May cause an allergic skin reaction.
FrescoAspira is on sale at household appliance stores, at Polti
Authorised Service Centres or on the site www.polti.com.
WARNING:
- Keep out of reach of children.
- IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
Contact a POISON CENTRE or a doctor immediately.
- Do not get in eyes, on skin, or on clothing.
- Harmful to aquatic life with long lasting effects.
- Avoid release to the environment.
- Dispose of in conformity with local regulations.
WARNING: Do not lift the appliance with the telescopic tube
and the brush in the parking position.
- Remove the damaged washer.
- Insert the new washer, applying it on the
steam nozzle and pushing it into place.
- Lubricate the gasket with silicone grease or
Vaseline, or alternatively with small quanti-
ties of vegetable oil.
RIDGING
WARNING: The rubber inserts must be inserted with the finely-
ridged part facing the outside of the brush.
F
R
F
R
UNICO MCV80-MCV85 - M0S11431 - 1Q09:UNICO 30/08/2016 16.17 Pagina 39