2
June 7, 2004
PAGER PROGRAMMING SOFTWARE
Product Family Alpha Elite
Getting Started
Equipment Setup
Refer to Figure 1 while performing the following steps.
1.
Plug the appropriate connector of the interface cable into the Programming
Interface. Connect the other end of the cable to the serial port on your computer.
2.
Plug one end of the coiled cable into the Programming Interface. Plug the other
end into the Pager Mechanical Interface.
3.
Plug the power supply cable into the Programming Interface and plug the
ac/dc adapter into a 120 Vac (or 220 Vac) electrical outlet.
➧
The program uses COM1 as the default communications port. If both a serial
port and a modem are used on the computer, it is recommended that COM1 be
used as the serial port. If COM1 cannot be used, change the default to COM2 in
the computer configuration screen when installing the software.
G
Use only the Unication-supplied cable for connection between the Programming
Interface and the Pager Mechanical Interface. Use of non-approved cables can
result in improper operation and/or incorrect programming of the pager.
AIPB 942418-C
Figure 1. Equipment Connection Diagram
COMPUTER
RS232 INTERFACE CABLE
(*3005020S09/10)
PRODUCT FAMILY 56A
FLEX PAGER
PAGER
MECHANICAL
INTERFACE
(**0102719J35)
* This item is part of the
Programming Interface kit
** These items are part of the
Programming Package