Unical TOUCH SCREEN N, User'S And Installer'S Manual

Page: 15 / 44

Touch Screen
15
Figure 14. Ethernet network configuration page
On this page there are the addresses for the configuration of an Ethernet connection.
A parameter is present to also assign the connection port (parameter 65, port 80 default).
Logging in with maintainer/manufacturer permission, you can change the default addresses.
It’s implemented a local web server to access to the Touch Screen from local area network with a HTML 4.01 compatible browser
(see Paragraph 5.2).
3.5 SECOND MAIN PAGE
From the home page, touching the arrow icon to accede to the next screen, you can get access to a second screen of all
measurments carried out by the temperature sensors and humidity sensors in the system.
Figure 15. Second Main page
Referring to the figure above:
• The field 1 indicates the zone to which you are referring. When pressing on it, you enter in the next area, scrolling cyclically
through the setting zones.
•
The field 2 indicates the fan coil which is referenced within the zone selected from the field 1; pressing on it the index of
the selected zone progresses in a cyclic manner, giving away all the fan coil units in the area. For each fan coil is shown the
detected air temperature. These indications appear only if there are fan coils configured in the system.
•
The field 3 indicates the chiller which it refers; by pressing on it, you progress to the next chiller in the network. For each
chiller shown, you see the readings on the temperature of the water inlet and outlet of the chiller and on the air
temperature measured by the probes on board.
• The field 4 shows the ambient temperature and the relative humidity measured by the sensors integrated in the Touch
Screen panel.
•
The field 5 indicates the presence of the solar system; then the indication on the temperature of the solar panels is shown.
These indications appear only if in the system is configured a solar panel.
• The field 6 shows the enabling of domestic hot water production related to the selected chiller. It indicates the
temperature of the domestic hot water.
•
The field 7 indicates the presence of a storage tank connected to the selected chiller. The display will show the temperature
of the plant storage tank when enabling the water plant remote sensor. Whereas it will show the temperature of the DHW
tank if the hot water production is avtivated.
• The field 8 indicates the presence of radiant floor; this field is connected to the enablement of double set –point function.
In the case of faulty sensors or if are not properly configured and/or connected, it will appear the indication of error.
Note: The presence of DHW tank is referred to the fact that in the network is present a heat pump enabled in the DHW mode.
5
3 7
4
1
2
6
8