USF-1600 User Manual
- page 23 -
b.
Perform the calibration test (dose calibration)
You can perform the calibration test when the seeder is ready for operation
.
Have you prepared the seeder and its metering components for carrying out the
calibration test, as specified in the description (see page 39)?
The box is filled with enough seeds. Do not fill the box too much, as it may be
necessary to dismantle or adjust the dispenser groove units.
1.
2.
In the main menu, press the buttons:
>
> (
)
⇨
«
Settings / Dispenser
»
menu is displayed
3.
-
If you use multiple dispensers, select the one, for which the
calibration test is to be carried out.
⇨
You can find the selected dispenser by the number displayed at the top of the
menu
.
4.
Enter the
«
Target value
»
, with which you want to work.
5.
Press the dispenser button, for which the calibration test is to be carried out, e.g.:
or
⇨
«
Calibration test
»
menu is displayed
6.
Enter the speed, at which sowing will take place
in the box under
«
Correct speed?
»
7.
-
Fill the dispensing units with seeds
.
⇨
The metering units rotate for a few seconds.
8.
- Start the calibration test.
9.
Start the calibration test on the seeder
.
10.
Wait until the desired amount of seeds or fertilizer is obtained
.
11.
Stop the calibration test on the seeder
.
⇨
Menu with the text
«
3. Quantity
»
is displayed.
⇨
The machine calculator will determine the weight on the basis of the
available data and display it in the field next to the text
«3. Quantity»
. It may
turn out that the displayed weight is different than the weight obtained
during the calibration test.
12.
Weigh the material collected into the container during the calibration test.
Enter the weight value in the box next to the text
«3. Quantity».
⇨
The machine calculator will determine the minimum and maximum speed, at
which you can obtain the seeding rate with the used groove unit.
Procedure
