UTD1000 User Manual
Appendix C : Maintenance and Cleaning
General Care
Do not store or leave the Oscilloscope where the LCD
display will be exposed to direct sunlight for long periods
of time. Caution : To avoid damage to the Oscilloscope
or probes, do not expose them to sprays, liquids, or
solvents.
Cleaning
Inspect the Oscilloscope and probes as often as
operating conditions require. To clean the exterior
surface, perform the following steps :
1. Remove loose dust on the outside of the Oscilloscope
and probes with a soft cloth. When cleaning the LCD,
use care to avoid scratching the clear protection film of
the LCD.
2. Use a dampened but not dripping soft cloth to clean
the Oscilloscope. Remember to disconnect power. Use
a mild cleaner or water. To avoid damaging the product
or probe, do not use abrasive chemical cleaner.
Appendix B : Accessories for UTD1000
Oscilloscopes
Standard Accessories :
● Two 1.
2
m, 1:1 (10:1) passive voltage probes. For
details please read the probe manual. EN61010-031 :
200
8
standard.
Rating is 150V CAT II when the switch is in the 1X
position;
Rating is 300V CAT II when the switch is in the 10X
position.
● One international standard power cord.
● One User Manual.
● Two current-to-voltage converter module : UT-M03/
UT-M04
● DC adaptor
● Test lead
All accessories (standard and optional) are available by
order at your local UNI-T dealers.
Summary of Contents for UTD1000 Series
Page 1: ...P N 110401104796X MAY 2018 REV 3 ...
Page 2: ......
Page 100: ... UTD1000 User Manual This user manual may be revised without prior notice ...
Page 101: ......
