Page | 8
3
TURNING ON YOUR KANEGA LTE WATCH FOR THE FIRST TIME
We know how excited you are to start wearing your Kanega LTE watch. There are a few simple
setup steps to complete before your Kanega LTE watch is ready to wear. Please watch our
educational videos at www.unaliwear.com/support.
1.
Fully charge your Kanega batteries before inserting them on the watchband
2.
Install the Kanega batteries on your watch for the first time in a location with a
good cellular connection.
The initial set-up may take up to ten (10) minutes. During the set-up
process, the screen displays
‘Kanega
LTE Watch
’
and then
‘
Setting-
up’
.
When ready, it displays
‘Press crown to begin’
and is ready for you to
listen to a short tutorial.
4. Listen to your voice tutorial.
a.
Please wear your watch during the tutorial.
b.
One (1) short press of the crown button starts the tutorial.
c.
The voice tutorial will teach you:
▪
How to communicate with the watch
▪
How the watch communicates with you, and
▪
How to contact an operator at the monitoring center.
Note:
Once the “
Press crown to begin
”
screen appears you have one (1)
minute to press the crown button. If you do not press the crown button
within one (1)
minute you see a ‘
Back to sleep
’
screen, and the watch
returns to sleep to conserve battery. To wake the watch, press and hold the
crown button for approximately three (3) seconds. Release the crown button
when the display turns on.
If during set up the watch does not have strong enough cell signal to make a test call to the
operator, it will let you know by voice and text to call support.
4
BATTERY CHARGER
Your Kanega LTE watch battery charger is designed to charge the Kanega LTE watch batteries.
It charges a maximum of three (3) batteries. Normally you only have two (2) batteries charging
at once because the other two (2) batteries remain on your watch.
Battery charger layout
