3
3. Installation and Storage
3.1 Cautions for Installation and Storage
See "Warning" (1), (2), (3), (5), (6), (7),
(8), (9), (10), (11), (12) and (13) on p.04
and p.05.
See "Caution" (1), (2) and (3) on p.05
and p.06.
See "Note" (1), (2), (3) and (4) on p.07.
3.2 Environmental Conditions for Installation, Storage, and Operation
The fine clearances used in this pump require that the following conditions be satisfied during
storage, installation, and operation.
(1) Ambient temperature of 0-40°C and maximum relative humidity of 85% during operation.
(2) Other conditions (during storage and operation)
a) Level floor of sufficient strength
b) No condensation
c) Dust-free environment
d) Well ventilated
e) Environment free of corrosive or explosive gas
f) Not subject to direct sunlight
g) No danger of fire
h) Maximum ambient temperature of 40°C when connecting the pump.
i) Sufficient space is available on all sides of the pump, and the pump cooling fan inlet is
not blocked.
3.3 Location
The pump should be installed level in a location with minimal dust and humidity. This location
should be selected in consideration of ease of installation and removal, inspection, and
cleaning.
Particular attention should be paid to ambient temperature when fitting the pump to equipment.
Use anti-vibration rubbers to isolate the pump from vibrations in the equipment. See 3.2
Environmental Conditions for Installation, Storage, and Operation for details.
3.4 Operational Checks Following Installation
1) Remove the rubber cap and vent plug on the inlet pipe.
2) Remove the four screws in the terminal box cover, pass the power cord through the
SKINTOP, and connect to the terminal block. Fit the appropriate crimped connectors to the
end of the cord.
Caution: Ensure that the power cord is appropriate for the rated voltage and current.
Caution: Use a 4-core cable, with each core wire having a cross-section area of 1.0 mm
2
or
more. Use one of the core wires as an earth wire.
Caution: Use M4 terminal block screws with SKINTOP compatible cable of 6 - 12 mm
diameter.
!
Warning
!
Caution
!
Note
