Ulvac DC-10, Operation Manual, Page: 28 / 88

DC Power
【
DC-10/DC-20
】
4. Description of Functions
17
4-1-2. DC power back panel
①
②
③
④
⑤ ⑤
⑨ ⑧ ⑦ ⑩
⑪ ⑫ ⑬
⑥
Figure 4-2: Back of DC power
Table 4-2: Name and function on back of DC power
N
ｏ．
Name Shape Function
①
AC INPUT Connector Check that the connector lock for the AC input is locked.
②
Name plate
－
Indication of Model, S/N, etc.
③
DC OUTPUT Connector Check that the connector lock for the DC output is locked.
④
USER IO PORT D-sub 37-pin connector Connector for external control
⑤
Ground terminal M5 stud Enclosure ground terminal* 1
⑥
Breaker Circuit breaker The AC input is supplied to the power supply or shut off.
Upper: supply; Lower: shut off
⑦
M/S configuration
switch*3 Rotary switch Before Master/Slave operation, make the settings*. 4
⑧
M/S connector
(female)*3 D-sub 15-pin connector Before Master/Slave operation, make connections.
⑨
M/S connector (male)*3 D-sub 15-pin connector Before Master/Slave operation, make connections.
⑩
SERIAL
communication port D-sub 9-pin connector Use in the RS232C/RS485 communication mode.
⑪
P configuration
switch*5 Slide switch This is not used. The factory default setting is the N side.
⑫
USB connector*5 USB This is not used.
⑬
Mode configuration
switch*5 Piano switch This is not used. The factory default settings are all in the
upward direction (on the OFF side).
*1: When using a separately available input cable, establish grounding with the ground wire on the side of the input cable.
*2: Only M/S function built-in equipment has this function. A standard model does not have.
*3: The respective switch position depends on the number of connected M/S units. See Section 3-3-4.
*4: This is used for maintenance. Do not make any settings. If any changes are made accidentally, reset to the factory default
settings.