Ulvac DC-10, Operation Manual, Page: 24 / 88

DC Power
【
DC-10/DC-20
】
3. Preparation
13
Figure 3-5: Connection diagram of M/S cable on back of power supply
3-3-4 Name definition of power supply with M/S connected
The name of each power supply with M/S connected is as shown in Table 3-3.
Table 3-3: Name of each power supply with M/S connected
Number of connected units Name
1st unit Master
2nd unit Slave1
3rd unit Slave2
・
・
・
・
11th unit Slave10
12th unit Slave11
3-3-5 M/S settings
The settings need to be made according to the power supply system configuration.
The M/S configuration switch in Fig. 3-4 needs to be set to its corresponding point.
Selecting C or its subsequent ones displays MODULE ERROR.
Setting the M/S configuration switch to the same point with different power supplies also displays
MODULE ERROR.
Master時
0
1
2
3
4
5
67
8 9
Slave1 Slave5
・・・・・・・・・・・・・・
0：Master
1：Slave1
2：Slave2
・
・
4：Slave4
5：Slave5
A
B
C
D
E
F
0
1
2
3
4
5
67
8 9A
B
C
D
E
F
0
1
2
3
4
5
67
8 9A
B
C
D
E
F
Figure 3-6: Setup of back switch of power supply in M/S
When setting the back switch, kill the upper-stream breaker and make the
settings using the supplied insulated screwdriver for the M/S setting or a
precision screwdriver with an insulation property.
This power supply uses high voltage. So do not put the screwdriver in other
than the switch.
Master
Slave1
Slave2
At Master
WARNING