22
NOTE:
1) Repeat Steps 5 through 12 if adding another add on unit.
2)
If this is the last 4 drum roll top to be added, use the existing sidewall and
follow the remaining steps to do so.
Step 13
Install the two bottom threaded rods (12) into the interior wall nut assemblies
(1) about ¾” Make sure that the black covers (10) are on the threaded rods (12)
and that there are jam nuts (3) on the end that is being installed.
Note: If this is an existing assembly with an interior wall (8) on the end. The hex
head bolt (6) and hardware will need to be removed from the roof (9) and
interior wall (8). It will be reused in Step 17.
Step 14
Slide the pallet (7) back into place. Take the end wall (14) and place into position
on the pallet (7) sliding the threaded rods through the end wall holes . Place a
washer (11) and locknut (5) onto the 2 bottom threaded rods (12) and tighten
until the wall is secure and won’t fall. Then slide the top two threaded rods(12)
through the end wall with the washer (4) and locknut (5) attached to the end.
