ULTRAFRYER REO-1620, Operation Manual

Page: 11 / 26

A. INSTALLATION
1. Place the Rethermalizer in the location where it is to be operated.
2. Have a licensed plumber level the Rethermalizer and connect a 1 2" (13 mm) copper water line equipped ⁄
with a WATER SHUT-OFF VALVE to the WATER SOLENOID VALVE mounted to the rear of the
Rethermalizer.
3. NOTE: A provision for all pole disconnection from supply mains must be incorporated for fixed
wiring
NOTE: Water hardness may affect the performance and longevity of component parts coming
in direct contact with the water. Therefore, the local water supplier should be contacted
to determine if the water to be used with the appliance
should be treated with a filter, strainer, softener, and/or des-
caler.
3. Have a licensed electrician perform the following:
a. Connect an CE approved 3 wire electrical cord
to the terminals inside the units electrical box shown to the
right:
b. Install an approved electrical plug on the electrical cord.
c. Install a “mating” rated electrical receptacle on the
wall behind the Rethermalizer operating location.
d. Connect the building ground to the ground lug located on the
outside of the unit.
4. Test the Rethermalizer as follows:
a. Ensure the controls listed below are in the proper position:
1. APPLICABLE CIRCUIT BREAKER IS ON
2. ELECTRICAL PLUG IS CONNECTED TO THE
ELECTRICAL WALL RECEPTACLE
3.
WATER
SHUT-OFF
VALVE IS
OPEN
4.
DRAIN
VALVE LEVER IS
CLOSED
GROUND LUG
TERMINALS
ON/OFF
SWITCH
GREEN
WATER
LEVEL
THERMOSTAT TEMPERATURE DIAL
RED HEAT INDICATOR HI LIMIT SWITCH
30A243
AMBER POWER ON LED
FRONT PANEL (FRONT & BACK)
11