PAGE 7
INSTALL GUIDE
14 Pin Power Connector
Step 2- Plug-In The Module
Step 3 - Test The System
When all the connections are done, the control module can be plugged in.
Before connecting the control module, make sure the ignition is in the
OFF
position. Plug in the 13 pin harness then followed by any other connectors that
were used. The system will confirm with two siren chirps and park light flashes.
Black Ground Input
System ground input.
Yellow Ignition Input
Input from vehicles ignition wire.
Red Main Power Input
Constant power input.
White (+) Park lights
Programmable - menu 2, setting 3.
Brown
(+) Siren Output
Positive output for siren.
Green* (-) Door Input
Negative door pin switch input.
Purple* (+) Door Input
Positive door pin switch input.
*Test for door pin type (Positive or Negative) then connect the
appropriate wire (Green or Purple)
1. Open all the vehicles windows.
2. Press the Lock button to arm the system.
3. Wait five seconds (or until the dome light goes out) then reach in
through a window and open the door. The alarm will then activate
(repeat on all the doors).
4. Test the Shock Sensor again and adjust if necessary.
5. Insure that all additional features are working as intended.
6. If necessary proceed to Program Mode to adjust the programmable
outputs.
Quick Start Install
Step 1 - Connect All Of the Following Wires
Your Basic Install Is Complete!
